Split-type Triple-frequency Power Supply Generator Common Test Equipment - Yangzhou Darui
Darui Electric recommends for you
Insulation safety tools, transformers, circuit breakers, insulators, etc. Test the insulation resistance, absorption ratio, and polarization index of transformersGD3125 Insulation Resistance Tester DC leakage test of transformers GDZG-500 series Intelligent DC High Voltage Generator Circuit breaker fracture withstand voltage, overall ground withstand voltage after closing, and AC withstand voltage of transformers; Insulation safety tools withstand voltage and insulators, etc., other insulation withstand voltage tests. YD series Oil-immersed Test Transformer GDYD-A Intelligent Power Frequency Withstand Voltage Test Device (station) GDFQ series Remote Discharge Ball Gap Transformer, PT, CT, arc suppression coil, reactor testing. Test whether the coils of transformers, PT, CT, reactors, etc. have internal poor soldering or inter-turn and inter-layer short circuits, as well as measurement of transformer tap positions. GDZRC-100A DC Resistance Rapid Tester Test the transformation ratio group, PT, single-phase transformer ratio polarity, etc., to understand whether the ratio, group, and polarity meet the requirements for parallel (series) operation. GDB-Ⅱ Automatic Transformer Ratio GroupTester TransformerNo-load and load test, check the no-load loss and load loss of transformers, and verify whether the transformer meets energy-saving standards. GDBR-Ⅳ Transformer Capacity and No-load/Load Tester Transformer capacity test, verify whether the transformer capacity meets the design requirements. Circuit breakers, load switches, etc. Measure the contact resistance of circuit breakers, load switches, etc. in the closed state to see if they meet operating conditions. GDHL-200A Intelligent Loop Resistance Tester Test the time characteristics and mechanical characteristics (dynamic characteristics) of high-voltage circuit breakers to understand whether they meet system operation requirements. GDKC-6A High-voltage Switch Dynamic Characteristics Tester Vacuum test of vacuum circuit breakers to see if they meet arc extinguishing conditions. GDZK-IV Vacuum Switch Vacuum Degree Tester Zinc oxide arrester Measure U1mA and 0.75U1mA of zinc oxide arresters to check the residual voltage characteristics of the arrester. GDYZ-302 Full-function Zinc Oxide Arrester Live Tester CT (current transformer) Measure the 5% or 10% error curve and ratio, polarity of CT to verify whether it meets the requirements of protection devices. GDFA-808 CT Volt-ampere Characteristic Comprehensive Tester Microcomputer integrated protection device Test the setting values of microcomputer integrated protection devices, conduct whole group project tests, and linkage project tests. GDJB-1200 Microcomputer Relay Protection Tester High-voltage cable Cable fault tester, to handle the fault points of faulty cables. Note: This item is recommended outside the regulations GD-2137 Cable Fault Test System AC withstand voltage test of high-voltage cables, to verify whether the cable heads processed by the cable can meet the requirements of operating voltage. Because the implementation of power frequency withstand voltage is poor, it is recommended to use variable frequency series resonance test device GDTF series Cable Variable Frequency Series Resonance Test Device Line Phase verification of lines GDHX-8000 Wireless High-voltage Phase Verifier Insulating oil Dielectric strength test of insulating oil in oil transformers, oil CT/PT and other equipment to verify whether it meets insulation requirements. GD6000A Different Frequency Dielectric Loss Automatic Tester
Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.
