Complete Low-Voltage and High-Voltage Switchgear Power-On Test Bench Technical Conditions
Darui Electric recommends
Input power: Three-phase four-wire AC 380V
Output voltage and current:
1. Three-phase AC 0 – 10A output (<100V, adjustable) one set
2. Three-phase AC 100V output (fixed value) one set
3. AC operation voltage output AC 0～400V, at 220V, current less than 10A
4. DC operation voltage output DC 0～260V
5. DC closing power supply output DC 0～300V (rated current 100A, short-time working current 300A) one set
6. Single-phase AC 220V output (fixed value, socket form) two sets,
7. Three-phase AC 380V output (fixed value, terminal) one set,
8. Dimensions: 560*520*850mm
9. Weight: 45kg
Complete Low-Voltage and High-Voltage Switchgear Power-On Test Bench Main Features:
(1) Integrates multiple AC and DC power supplies, facilitating the testing of switchgear and greatly improving work efficiency.
(2) Uses independent transformers and voltage regulators for boosting (current), avoiding damage to the voltage regulator.
(3) Primary components inside the box adopt products from well-known domestic brands; measuring instruments for current, voltage, frequency, etc., use 0.5-class digital meters, and sensors (current transformers, voltage transformers) use 0.5S class.
(4) Uses anodized brushed aluminum panel, wear-resistant, dirt-resistant, and more aesthetically pleasing.
Introduction
It can provide various AC and DC power supplies, facilitating the testing of switchgear and improving work efficiency.
Technical Parameters:
Input power: Three-phase four-wire AC 380V
Output voltage and current:
1. Three-phase AC 0 – 10A output (<100V, adjustable) one set
2. Three-phase AC 100V output (fixed value) one set
3. AC operation voltage output AC 0~400V, at 220V, current less than 10A
4. DC operation voltage output DC 0~260V
5. Single-phase AC 220V output (fixed value, socket form) two sets,
6. Three-phase AC 380V output (fixed value, terminal) one set,
III. Instructions for Use:
1. Connect three-phase four-wire AC 380V
2. Connect the output DC 300V to the load
3. Rotate the output adjustment knob counterclockwise to zero.
4. Check and confirm the wiring is correct
5. Close the power switch
6. Slowly adjust the output adjustment knob to raise the voltage to a suitable value.
7. After the test is completed, first rotate the output adjustment knob counterclockwise to zero, then turn off the power switch. Only after the discharge is complete can you start disconnecting the wires.
Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.
